HDC1050EVM

EVAL BOARD, HDC1050 TEMP/HUMIDITY SENSOR.

The HDC1050EVM is an Evaluation Module for evaluate the operation and performance of HDC1050, a humidity and temperature sensor. The board utilizes USB interface for control and data streaming and can be too plugged into a PC USB port. With the simple GUI, humidity and temperature measurements can be streaming within a matter of seconds after the EVM is attached to a PC and the GUI is started. The board hosts a MSP430F5528 MCU which acts as a bridge between the PC USB interface and the I?C interface to the HDC1050. The sensor section of the PCB may be separated from the main PCB to support prototyping in a system where the sensor is remotely located from the host controller. The board does not require calibration, nor does it require any software programming - only the board GUI must be installed. Temperature and relative humidity data can be logged and exported in CSV format.